1030nm, Fabry-Perot Single Mode Laser Diode in Pre-Configured Pulse & CW Mode Control and Mount Module:
- 700mW Peak Pulse Output Power
- User Replaceable Laser Diode

Product Overview:

Pre-Configured 1030 nm Source Fine Tuned for Clean Ultra-Short Pulse Performance:

These pulsed and CW 1030 nm laser source & control modules offer the user a pre-configured, calibrated solution for fast pulse seed and sensing applications. These modules deliver pulse widths as narrow as 1 to 3 nanoseconds. The butterfly packaged laser diode has been impedance matched to the pulse current PCB in the mounting socket to ensure clean pulse performance with almost no ring or overshoot. To achieve the shortest possible pulses, the customer has the option to request that the butterfly package be soldered into the mounting socket. These modules are designed primarily for pulsed fiber laser, direct frequency conversion and spectroscopy applications which require a narrow spectral bandwidth and high peak power.

• SIMPLE TO OPERATE:

  System ships with 1030nm laser diode installed and tested in pulse & CW control electronics and mounting module.
  

• FLEXIBLE:

  User can remove and replace the laser diode in the future as needed
  

• INSTALLATION SUPPORT:

  Get up and running fast with unlimited phone & email tech-support; see contact info in the images section.

Pulsed 1030 nm Laser Diode Control Electronics and Butterfly Mounting Module:

The control electronics and mounting module for these lasers delivers high stability current pulses which can be generated internally by an on-board pulse generator or on demand from an external TTL signal. The external trigger source can be used to trigger the pulse parameters which are preset in the control module. These control modules offer multiple mechanical, thermal and electronic protection features for the laser source. They ensure that your laser diode is protected and operated safely. The on-board TEC controller incorporates a fast feedback PID control loop to provide high temperature set-point stability. A user-set temperature limit keeps the source from thermal damage. Additionally, multiple bias current / voltage protection features are designed to keep the source safe from ESD, power outages and reverse voltage. A user controlled current limit clamps the current in both Pulsed and CW mode.

USB and Control Software:

The user can set and monitor all of the control parameters of the 1030nm source laser using the USB input and the supplied GUI software. These units ship with the USB cable to connect your PC to the connector on the side panel. A simple to use, single page graphical user interface allows you to control all of the pulse or CW parameters as well as set current and temperature limits. Other features of these control modules include a daisy chain output, sync output, alarm monitor and back facet monitor output to monitor the laser power.